PET Vapour Barrier for Vysa-Film Floor Heating Elements 130W/m2 and 160W/m2
Once the Vysa-Film has been installed, and before laying the final floor covering, a layer of Polyester Vapour Barrier (PVB) must be used to cover the whole Vysa-Film underfloor heating system. The PVB provides:
1) Additional mechanical protection against damage to the Vysa-Film by chaffing as slight movements of the final floor can damage the Vysa-Film .
2) Additional supplementary electrical insulation as a requirement of the BS EN 60335-2-96 Approval Certificate.
3) Additional protection against mass spillage of liquid on the finished floor. The joints where adjacent edges of the PVB film meet must be overlapped by a minimum of 100mm. They should then be covered with waterproof, strong adhesive tape (50mm wide Vysa-Bond SAT – order code 2465) along the entire joint length.
To install PVB, simply roll out the PVB film, cut to length and overlap adjacent pieces by a minimum of 100mm.
Tape along the entire length of the overlap using Vysa-Bond SAT fixing tape (1 roll of PVB will require approximately 25m of Vysa-Bond SAT fixing tape).
The Polyester Vapour Barrier (PVB) is required to provide additional supplementary insulation and is a mandatory requirement of the BS EN 60335-2-96 Approval Certificate.
PVB is available as required 1m x number of metres required or as a complete 1m x 25m roll.
Don’t forget to order 50mm wide x 25m rolls of Vysa-Bond SAT fixing tape.
For more product information visit www.floor-heating.co.uk